Inverness in Feb 2020

2020 - Jan to July

I went to Inverness on business 14th February.  The night before I arrived late and stayed at the Ardtower site on the city's outskirts.  Nowhere else was open.

After business I want to Fort George.  


I was surprised that there is still a military presence, probably as a base for training in the remote areas.  

Rather than race home I thought I'd take the scenic route to Braemar via the ski resort at Lecht and the Cairngorms.  It was pretty easy going until the snow started falling at the summit by the ski station and the wind whipped up.  It was already dark and for a moment I had a few doubts.  

But not a problem for Daisy and I stayed one night in Braemar.  

it was the Covid spring and I didn't get out until July.

Comments

Post a Comment

Popular posts from this blog

Habitation Wiring

Image
Habitation Wiring Diagram Daisy's habitation wiring is essentially four largely separate circuits. The simplest is a transformer located on the bulkhead behind the battery and connected to the hook-up 240v. Charge is supplied to the battery via a diode which ensures there is no loss of charge across the transformer when the hook up supply is not connected. The transformer has its own built-in fuse. The second circuit comprises a lead from the vehicle ignition (A14) which closes a relay (R1) to complete a circuit between the vehicle and leisure battery when the ignition is on. This lets the alternator charge the leisure battery when in motion. More modern vehicles have technology to reduce the alternator current if the vehicle battery is fully charged so that fuel is saved. This then needs a more sophisticated circuit. Daisy does not need this complexity. Diode D1 has been added because otherwise the starter motor circuit takes power from both batteries. This can be...
Read more

Removing the fridge, heater and hob. Notes for next time!

Image
Removing stuff I took out a few things to find a water leak.  These are my notes. To remove the hob: Gas off Remove drawer under hob Loosen four corner screws holding the hob in place.  Use a minature socket set. Push the retainers away from the work surface. Unscrew the hex nut at the back of the hob where the gas comes in. Lift out the hob To remove the sink Remove the hob. Remove the screw in the sink waste. Follow 3 and 4 above.  Note that the back right screw is a bugger to reach and loosen. Lift the sink out, noting that there are metal brackets on each side which need to be folded back. Undo the bolt holding the earth strap in place. To remove the fridge Remove the sink. Remove the knobs Remove the two screws holding the facia in place Run a knife around the fridge to remove sealant. On the sink side of the fridge there are two screws near the vertical shelf.  You removed the sink to get access to these.  Remove them...
Read more

Ireland for two - May 2019

Image
Trip to Ireland - May 2019 After my daughter's Higher Exams we took some time to travel to Ireland.  This was the first time we had used Daisy with one person sleeping in the overhead space and the other on the bed made up from the table area.  It worked very well - not over-crowded and we slept fine. Day 1 - Home to Maybole I am not sure of there is much of a village here - it is a dot on the map about 7km east of Turnberry on Scotland's east coast.  But where is a lovely and secluded campsite called the Walled Garden.  Very peaceful, with walks along the wooded riverbank and, usefully for us, not too far from the ferry port. Day 2 - Maybole to Belfast The ferry from Cairnryan departs at 11am.  So we left the campsite at 9am and expected to be far too early. But the road to the coast was closed and we had to take a back road detour.  But we made it in time to join the ferry with a lot of motorbikes.  On the ferry we decided to stay at ...
Read more